Here is a link to a tutorial that will walk you through installing version 2 of the Arduino TFT LCD Touch Screen

This channel offers coverage for a wide range of boards, including, amongst others, Arduino, raspberry PI, esp8266, and esp32

 

 

This channel offers coverage for a wide range of boards, including, amongst others, Arduino, raspberry PI, esp8266, and esp32. The 2.8-inch touch screen will be driven by an Arduino Uno and an esp32 board, respectively.

 

Let's begin by centering our attention on the monitor by itself and taking a more in-depth look at it so that we can get a sense of our surroundings. The price of display is approximately $11 per item, and I believe that this is a reasonable price for what the show has to offer; therefore, I do not believe that the price of display is unreasonable. Additional citations are required.

 

If I click the close button on this window, you can see that the number 1 will be transmitted. Following each command, there is a sequence of three bytes that are completely read out. I began a new project, as well as a new screen, and I proceeded to add a background just as I had done previously. On the other hand, I now have the ability to choose a button, select a number, and have it add a new number block to the display. In the event that I choose to change the background, the color of the block will be gray, the text will be white, and I will also locate the number zero. To give you an example, the last time I used it, I gave the block a width of 200 pixels and a height of 30 pixels, just to give you an idea of what I was talking about.

Now we are going to discuss a sizeable portion of the entire thing. Moving forward, I will refer to this thing as voltage 1, and the value it possesses will not change in any way. What we now need to do is send this line voltage 1 from Arduino, small tft display followed by Val equals, and then enter the number that we want to display on the screen. After we have completed these steps, we can move on to the next step.

Now you need to make connections between these components and the screen as well as the potentiometer so that you can mimic the input of a zero. After that, I write three complete bytes, which is what causes the code to be compiled and uploaded to the device. After that, I print the value of the potentiometer. This voltage corresponds to a single point val. I'm going to print the new value on the screen after I make this adjustment to the potentiometer first.

 

 


Allibone Charlie

4 Blog posts

Comments